[Dstar] ICOM IC2200 Gateway Issues

[Adrian]

"After checking a little further, when the callsign appears on the
gateway it doesn't show up on DPLUS."
RPT2 not set to VK6RWN G , most likely reason.Station/Repeater1/2 call sign programmingStation call sign must be programmed for the specified stationcall as well as repeater operation in both Digital voice andslow data communications.q Push [BANK ] for 1 sec. then push [BANK ] or[V/MHz] several times to select the call sign select mode.. "YUC" appears for station call sign.. "R1C" or "R2C" appears for repeater call sign.w Rotate [DIAL] to select the desired call sign channel thenpush [SET] or [MONI].e Push [MONI] (or [SET]) to set into call sign programming condition.. The 1st digit blinks and channel indication stops blinking.r Rotate [DIAL] to set the desired character or code.. Push [MONI] or [SET] to move the cursor to left or right, respectively.LOCKt Push [MONI] (or [SET]) to select 2nd digit, then rotate[DIAL] to set the desired character or code.. 2nd digit blinks (1st digit stop blinking).. Repeat this step for programming station/repeater call sign.y Push [V/MHz] to fix the call sign.u Rotate [DIAL] to select an another channel from "C1" to"C6."i Repeat steps w to y to program another station/repeatercall sign channels. "I am guessing it's a setup issue with the radio.  
Has anyone else had the same problem or can advise on how to set thisup?"

vk4tux
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.wia.org.au/pipermail/dstar/attachments/20090415/5a44f4a3/attachment.html